You will get your first harvest after 3-5 weeks! After this point you should get further flushes, so projects may keep going for an additional month or so after this. Keep this in mind when you're going on holiday!
You should see mycelium begin to form after 7-14 days post-inoculation. Following another week or two this should be around 85% of the way fully colonized.
If this is taking longer, the lighting may be too strong, too weak, or too direct. If you're worried about this, please email us photos of the lighting set-up to [email protected].
As soon as you see the first pins, keep an eye on the bag as they can mature within hours or days!
Our kits require the environment to be warm, humid and in low lighting to colonize and fruit. They also require a healthy airflow to be able to expel their CO2 and take in oxygen. Mycelium will go dormant and wait for these conditions, so we would recommend checking these prior to contacting us.
Heat mats must be used in the winter, as the majority of Gourmet Health Mushrooms must be around 26-27c to colonize and fruit. Warmer areas in your house are not guaranteed to be up to temperature or stable. Some areas (i.e., above the boiler, near a radiator) are not suitable as they will heat up over 35c. 35c is when spore death can occur, rendering your project dead.
When using a heat mat, it's important to ensure the temperature probe is situated correctly, otherwise the project may overheat. They should be kept directly under the kit, and directly above the heat mat.
During the winter, you may be tempted to wrap your project in a duvet or towel which will keep it warm, but will also imped airflow. Keep it in a clean spare room, or a spacious cupboard that you can keep warm and light.
Low-light conditions can be achieved with both natural and artificial light. This must be on for 24/7 after the initial inoculation. Therefore, artificial lighting may be preferred. If you're worried you may not have the correct lighting, send photos to [email protected] so we can assist you further!
NO. OPENING THE BAG EARLY WILL CAUSE CONTAMINATION.
Any mushrooms which look peculiar (i.e., Lions Mane, Turkey Tail, etc.) require additional air flow by cutting a cross into the bag when it's time to fruit. Any typical looking mushrooms (i.e., button mushrooms, chestnut mushrooms, etc.) do not need any additional support.
Once your project is moved into the light and pins are starting to rear their little heads, it’s almost ready to harvest your gourmet health mushrooms! It’s unlikely your mushrooms will mature all at the same time as this is an organic process. However, it’s incredibly important to harvest them before they fully mature and release their spores as that can cause contamination and bring an early end to your project. So, make sure to pick any mushrooms that are ready to pop their hoods whenever they pop up!
Make sure you harvest them between stage 3-4 to ensure your mushrooms don’t drop their spores!
Ensure you re-seal your bag with a small easy glide bag sealer if you'd like to get multiple flushes out of your bag!
It takes only three steps to promote a further flush (harvest) of your bag. Simply follow these steps below and you’ll have more gourmet health mushrooms in no time:
1. After your bag’s growth has stopped, simply open the bag and add a cup full of cold tap water to the bag. Let this sit (ensure it’s sealed) for 12 hours.
2. After 12 hours, your are ready to drain the excess - To drain the kit, you will lay the kit down diagonally in the sink. You will then want to to tip the kit slightly to encourage water to drain. Do this 3-4 times across 30 minutes. The block will only release a certain amount of water each time you tip it, therefore it has to be carried out multiple times to ensure the kit does not become waterlogged.
3. Place this bag (sealed) in the exact same conditions you had it in before for it to fruit successfully. Wait 7-14 days and you should have another flush!
Keep going until you exhaust your bags!
Yield size does not depend on the syringe amount used, but the amount of substrate used. There is a sweet spot for each bag on how much ml of spores to use, and how much yield you'd get from this. If you use too little, it may take much longer. If you use too much, it will effect the substrate and may drown the spores.
We would recommend 20ml of Gourmet Health Mushroom spores which will give you around 500g+ (when wet) of mushrooms at harvest. When you dry these mushrooms, they will shrink to 10-20% of their body weight when wet.
We do two types of 4lb inject and forget kits, our all in one oxygen release agent kit and our all in one light bags.
Our light bags require light 24/7 from inoculation and must not be mixed up at all until you can see a 50p piece of mycelium. You do not need to change the lighting, temperature or humidity of this project for fruiting to occur. Simply leave it alone in low, indirect light for it to fully colonize and fruit!
Our oxygen release agent bags must be mixed directly after inoculation, and kept in complete darkness until the substrate has been fully taken over with mycelium. To facilitate fruiting once the bag is fully colonized, introduce it to low, indirect lighting to begin the pinning process.
How Do I get Started?
- Start off by preparing your work surface. Give it a wipe down with some 70% Isopropyl Alcohol Spray. Using an incubation chamber? Give it a wipe down too! Let these surfaces dry and do not spray anything near/on your inject and forget bag as it could damage the integrity of the filter patch.
- Turn on your heat source and ensure it gets up to temperature. Your project should be kept between 26-27c. If using one of our 60L all in one fruiting and incubator’s, you don’t need to change any settings as it come’s preset. Simply plug in and play!
- Wash your hands then remove your bag from its protective outer plastic bag. Be careful not to touch the air filter too much as the oils from your hands can affect its integrity.
- Pop your Gourmet Health Mushroom syringe out of its silver foil packet, keeping the end cap secured until you’re ready to use the syringe.
- Open your needle packet from the top, remove the end cap from your needle and insert the syringe into the needle, careful not to trigger the plunger early. Keep the protective cap on the needle until you’re ready to inoculate (we’re not there yet!).
- Take out your alcohol wipe that comes with your bag and wipe the injection port of your bag (the small grey square sealed in plastic). You do not need to wipe or heat the needle as it’s a gamma irradiated, NHS grade needle. Therefore, sterilizing it further can cause contamination. Leave this to dry for a few seconds.
- Gently shake your syringe against your hand to shake up the spores. No spores should be left behind!
- Once you feel ready, take the protective cap off the end of the needle, and inoculate the bag. Ensure to tilt the syringe so it’s slightly angled downwards as you press the needle into the injection port, stopping halfway into the port. Push down the plunger and release your spores into the bag. If your plunger is stuck, slowly pull your syringe out (but don’t remove it from the port) and push the plunger down again.
- Pull the needle out and place your bag on the heat mat in an upright position (as it came).
- Put your project in constant (24 hour a day) low, indirect light and wait until you see mycelium emerge. You can use natural lighting, however artificial lighting can be more beneficial and easier to control. If you’re worried about whether your project is too dark/light, pop us an email with some photos at [email protected]. We’d be more than happy to help!
- Once you see at least a 50p piece of mycelium emerge in the bag, give it a bit of a mix to help speed the process of full colonization along. You can then place your bag horizontally, on it’s side, so the air filter and injection port is facing the side.
- Soon, this bag will be full of white fluffy mycelium and will fruit at this stage. You do not need to open or mist the bag to begin the fruiting process, just leave the bag to it!
Liquid Cultures or Spore Syringes? What’s the Difference?
- Featured
- By admin
Many people use the words “liquid culture” and “spore syringe” interchangeably, but the fact is these are two very different organisms. Both can be grown if given the right substrate and environmental conditions, but they have their differences!
Getting into Mycology
- By admin
Starting your journey into mycology can be scary and confusing. We’re here to help! Within this blog, we’ve compiled our knowledge to provide you with a beginners guide on what you’ll need to get into mycology!
Clean Shrooms: Tips to Keep Your Mushroom Kits Contamination Free
- By Lara
Contamination gets us all at one point or another. No matter your experience, you will run into it eventually. Arm yourself with the knowledge of how to identify, prevent and treat it where possible.
Which kit is right for me?
- By Lara
Sometimes it can feel pretty overwhelming when starting out. There’s so many different kits, so where should you start?